$ 249.95
Canon SKU:Â CA2478A002 | Helix SKU:Â CA2478A002
With the Speedlite 550EX and the Speedlite Transmitter ST-E2, it is now possible to use multiple Speedlites under full E-TTL control and without the need for any interconnecting wires. Developed in conjunction with the Speedlite 550EX and the EOS-3 camera, this master control device for a wireless Speedlite flash system meets professional and advanced amateur standards. Its dedicated transmitter controls up to 3 Canon 550EX Speedlites as slave units 33 feet away outdoors and 49.5 feet away indoors. It is mounted as a clip-on with a shoe lock lever and locking pin.
Compatibility:Â
• PowerShot G15 RefurbishedÂ
• Speedlite 580EX II RefurbishedÂ
• Speedlite 320EXÂ
• PowerShot G5 XÂ
• Speedlite 430EX IIÂ
• PowerShot G3 XÂ
• Speedlite 600EX-RT RefurbishedÂ
• PowerShot G3 X RefurbishedÂ
• PowerShot G15
• Speedlite 600EX-RTÂ
The Canon ST-E2 is commonly used for Fill flash, General purpose, Night photography, Portraits and more.The Canon ST-E2 is most used by customers who consider themselves to be a Photo enthusiast, Professional, Semi-pro photographer among others.The Canon ST-E2 is popular because customers like the following qualities of the Canon ST-E2: Consistent output, Durable, Easy to use, Fast recycling, Good power output, Lightweight and Versatile
Canon ST-E2 Features
Â
Â
$ 17.95
Graslon SKU: 4335 | Helix SKU: GL4335
 Lens for Graslon Insight flash diffuser
Â
$ 17.95
Graslon SKU: 4336 | Helix SKU: GL4336
$ 89.95
MagMod SKU: MMBKIT03 | Helix SKU:Â MMBKIT03
The bare necessities, one kit for each flash. Light control has never been easier.
What's included
1MagGrip
1MagGrid
1MagGel
1Standard Gel Set
1MagMod Transmitter Band
$ 24.95
MagMod SKU: MMGEL02 | Helix SKU: MMGEL02
The MagGel is the ultimate gel system for hot-shoe flashes. Let's face it: film-based gels with velcro or tape just flat out suck. So we improved on them. The MagGel is designed to let you swap out our rigid polycarbonate gels quickly and easily.
$ 34.95
MagMod SKU:Â MMGRID02 | Helix SKU:Â MMGRID02
Molded from a single piece of silicone rubber, the MagGrid’s carefully optimized beam pattern provides even light coverage and eliminates unwanted light spill, allowing photographers to capture cleaner and more consistent photographs.
$ 11.88 - Sold Out
This adapter converts Nikon flash mounts to a universal flash bracket. This replaces the Manfrotto 3298.
$ 13.65
Mfr SKU: 4962Â Â | Helix SKU: NK4962Â Â
Supplied stand to hold SB-700 in place during multiple flash set-up.
The AS-22 Speedlight stand is designed to hold the a Speedlight in place during wireless operation, for multiple flash set-ups.Â
It is supplied with the SB-700.Â
The AS-22 also features a tripod socket, allowing the Speedlight to be attached to a tripod or light stand.
Â
Â
Â
Â
Â
Â
Â
Â
Package Weight | 0.060 lb |
Box Dimensions (LxWxH) | 4 x 4 x 1" |
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
$ 3,667.95
Norman SKU:Â 810818 | Helix SKU: NR810818
Commercial Photographers need lighting equipment that will provide the power, repeatability and versatility required to handle the endless variety of assignments they encounter on a daily basis. Norman Series 900 equipment has always been able to meet these challenges, and the D12 and D24 Digital Power Supplies are no exception.
These 1200 and 2400 watt-second systems incorporate four lamphead outlets with digital displays and individual on/off switching. Power levels are adjusted through two channels, each with a five-stop range that are adjustable in 1/10 stop increments. You can also combine the two channels to deliver full power to a single lamphead or to create a symmetrical power supply.
Additional Features:
- Compatible with all Series 900 Lampheads and related light modifiers
- Optional software for complete control from your PC
- Photo eye, 1/4" sync jack and optional PocketWizardâ„¢ Radio Receiver
- Accurate digital controls with LED display for each lamphead
- Easy to use rotary knobs control power settings and modeling light levels
- Selectable audible and visual flash verification
- Misfire alarm for each lamphead
- Flash repeatability of 1/20 stop at full power
- Slow charge option allows shooting at locations with sub-par wiring
- Full two year limited parts and labor warranty
- Independent safety approvals including ETL, CETL and FCC
Norman Power Supplies are also available with built-in PocketWizardâ„¢ radio receivers. This unique feature allows these power supplies to be used in the studio or on location without the hassle of sync cords, and it eliminates the risk of inadvertent tripping of your lights from other strobes in the area. The built-in PocketWizardâ„¢ receiver can be set to operate from any channel selected on a compatible PocketWizardâ„¢ transmitter.
Having the PocketWizardâ„¢ receiver built into the D12R and D24R eliminates the need to carry and keep track of a seperate receiver module and compatible cable. Best of all, the built-in unit is powered directly from the power supply, eliminating the need for batteries.
1- LED Display:Â Displays the power in watt-seconds that has been set for that lamphead.
2- Power Switch:Â Switches AC power on/off. Internal memory retains settings.
3- AC Power Inlet: 115 volt 60HZ power input, stabilized to provide repeatibility of 1/20 stop at full power with AC line voltage fluctuations between 105-125 volts.Â
4- Reset 15 Amp Circuit Breaker:Â Automatically protects the flash circuit against excessive overloads.
5- Sync Outlets:Â Two sync outlets available for triggering from multiple cameras or meters.
6- Computer Control Modular Jack:Â Used to connect the power pack to a PC via serial port when using Norman Power Supply Communication Software.
7- Lamphead Enable:Â Allows a lamphead to be turned off without unplugging it.
8- Modeling Lamp:Â Can be set to full, ratio or off. Trim control brightens or dims without losing ratio.
9- Flash Verification: Audible verification will beep twice when the unit has returned to full power. Visual verification will cycle the modeling on and off, and then return to its previous state.Â
10- Combine:Â When the pack is in combine mode, all of the power in the power pack is distributed evenly to all lampheads that are enabled.
11- Photo Eye:Â Can be switched on to permit remote triggering from another flash source.
12- Slow Charge:Â When enabled the units recycle time is increased, which is useful when shooting at a location that has sub-par wiring.
13- Power Trim Knobs:Â Adjusts the flash output from full to -5 f/stops in 1/10 stop incrementsÂ
14- Test Button/Ready Light:Â Press button to manually flash unit. Switch will light when ready to be triggered.
15- Antenna:Â For built-in PocketWizardâ„¢ Radio Receiver.
|
*The guide number stated was determined by measuring the bare bulb at 10 feet using ISO 100.
See individual reflectors in this catalog for guide numbers using specific light modifiers at various power settings.
$ 129.00
The PowerST4 Receiver enables remote power control of Elinchrom RX flashes with a camera-mounted PocketWizard MiniTT1 Transmitter or FlexTT5 Transciever. PocketWizard ControlTL technology allows you to control the flash power level using the camera’s Flash Exposure Control (FEC). The PowerTracking feature automatically adjusts flash power to maintain the photographer-established level and thus proper exposure when the aperture and/or ISO is changed. Slide the new PocketWizard AC3 ZoneController into the shoe of the camera-mounted MiniTT1 or FlexTT5 and ST4 linked Elinchrom RX flashes can be controlled in three zones: A, B, and C in 1/3-stop increments over a six-stop range. The ST4 can also receive standard PocketWizard signals from a Plus, Plus II and MultiMAX transmitter. Set for Channel 1 at the factory, the ST4 can be easily set for any of the 20 ControlTL or 32 standard channels using the units' LEARN function or by USB connection with the PocketWizard Utility software. The PowerST4 draws its power directly from the Elinchrom RX flash remote control socket; there’s no need to install or replace batteries. The PocketWizard PowerST4 is a must-have for Canon photographers using PocketWizard with Elinchrom RX flash units.
$ 49.95
The PROMASTER Deluxe TTL Off-Camera Remote Cord allows you to extend the dedicated operation of your TTL flash when using the flash off of the camera on a bracket or other accessory.
Â
$ 99.95
ProMaster SKU: 9160 | Helix SKU: PR9160
The ProMaster Easy Fold Speedlight Soft Box allows you to use your camera mounted flash to produce a soft, diffused, natural light for pleasing photos of both people and objects. The soft box folds compact and includes a carry bag for convenient storage and transport. This easy fold kit comes with the soft box and all the mounting gear you need to attach your flash.
Includes:Â
-Â 24 x 24'' Soft BoxÂ
-Â Fully adjustable mounting bracketÂ
-Â Storage Case
CA Residents:Â Prop 65 WARNING(S)Â
$ 14.95
ProMaster SKU: 1154 | Helix SKU: PR1154
A diffuser creates softer, more even light from your electronic flash, giving your photos a more natural appearance. ProMaster Dedicated Flash Diffusers attach without the assistance of velcro or tape and are available to fit many popular shoe mount electronic flash units.Â
$ 29.95
The ProMaster LED Macro Arm Light consists of two lights on flexible arms designed for close-up shooting. It mounts to the camera accessory shoe and is powered by two CR2025 batteries. Each light operates independently and has two levels. Light direction can be easily adjusted, allowing for either elimination of unnecessary shadows or addition of enhancement shadows.
$ 24.95
ProMaster SKU: 4208 | Helix SKU: PR4208
Â
Â
$ 89.95
Stroboframe SKU: VH 2000 | Helix SKU:Â SF300100
The Stroboframe VH2000 is an ultra-compact, "gripless", flash rotating bracket. It cradles the camera unobtrusively while maintaining an over-the-lens flash position with a design that lets you hold the camera rather than a grip, and rotate the flash for horizontal or vertical composition. What's more, the stress and weight of the flash unit is transferred from the light-duty camera shoe to the rugged Stroboframe mount. The Stroboflip is made for shoe-type flash units.